Carton Contents; Charger Operation - sunjoe 24V-SS12-XR Manual Del Operador

Unpacking

Carton Contents

• Cordless snow shovel
• Handle assembly
• Knob
• Curved head bolt
• Saddle washer
• 24V iON+ lithium‑ion battery
• 24V iON+ lithium‑ion charger
• Manual with registration card
1. Carefully remove the cordless snow shovel and check to
see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage
or damage occurred during shipping. If you find damaged
or missing parts, DO NOT return the unit to the store.
Instead, please call the Snow Joe
service center at 1‑866‑SNOWJOE (1‑866‑766‑9563).
NOTE: Do not discard the shipping carton and packaging
materials until you are ready to use your new cordless
snow shovel. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging materials are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suffocation
risk!
Battery Pack Operation
The equipment is powered by a lithium‑ion battery. The battery
pack is completely sealed and maintenance‑free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
Lights Light Indicators
Charge level button
The battery is at 30% capacity
The battery is at 60% capacity
The battery is fully charged
+ Sun Joe customer
® ®
6
NOTE: If the battery indicator button does not appear to be
working, charge the battery.
NOTE: Immediately after using the battery pack, the battery
indicator may display a lower charge than it will if checked a
few minutes later. The battery cells "recover" some of their
charge after resting.

Charger Operation

m
WARNING!
Only charge Sun Joe
battery packs with compatible Sun Joe
chargers. Other types of chargers may cause personal injury
and damage.
To reduce the risk of electric shock, do not allow water to enter
into the charger.
Charging the Battery
1. Push the push lock buttons on either side of the battery
pack to pull it out from the battery compartment (Fig. 1).
Fig. 1
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the top right green light will illuminate
and stay green (Fig. 2).
Fig. 2
Power on
green
3. Place the battery pack into the charger by sliding the
pack to lock it into position. When you insert the battery
into the charger, the top right green light will go off, and
the top left red light will illuminate to indicate that the
battery is charging (Fig. 3).
24V lithium‑ion
®
24V lithium‑ion
®
Charger