SNOWJOE 24V-X4-SB21-CT Manual Del Operador página 10

Fig. 11
2. To switch the snow blower ON, press the safety button, then
squeeze the switch bar lever (Fig. 12).
Fig. 12
Switch bar
level
2
Safety button
3. Once the snow blower starts, release the safety button and
proceed with operation.
4. To power OFF, release the switch bar lever.
Adjust Auger Speed
This snow blower is equipped with auger speed adjustment
system, which can set the auger speed from low to high. Follow
the instruction to set the auger speed to fit in the working
environment. Consider the working time, snow volume, and
the surroundings when adjusting the auger speed. In general,
lower auger speed provides longer battery runtime, but smaller
plowing capacity and shorter throw distance. Check attached
table for the specs that can be affected by the auger speed.
MIN. Auger Speed MAX. Auger Speed
Throw Distance
25 ft (7.6 m)
1. To increase the auger speed, scroll the speed adjustable
Battery
compartment
cover
1
30 ft (9 m)
dial counterclockwise with the switch bar level squeezed
(Fig. 13).
2. To reduce the auger speed, scroll the speed adjustable dial
clockwise with the switch bar lever squeezed (Fig. 13).
Fig. 13
Speed adjusting dial
Reduce speed
Changing Throw Direction and
Throw Height
m
WARNING!
Never direct the snow discharge chute at the
operator, at bystanders, at vehicles or at nearby windows. The
discharged snow and foreign objects accidentally picked up by
the snow blower can cause serious damage and personal injury.
Always orient the discharge chute in the opposite direction from
where you, bystanders, surrounding vehicles or windows are
located.
1. The discharge chute can be adjusted 180 degrees by
pressing the chute rotate button in the desired direction
(Fig. 14).
Fig. 14
Press to turn
chute right
Press to turn
chute left
2. The chute deflector on the top of the discharge chute
controls the height of the snow stream. To adjust the height
that the snow is thrown, squeeze the trigger on the chute‑
deflector handle, and then raise/lower the chute deflector.
Release the trigger on the chute deflector handle to lock
the chute deflector in place (Fig. 15).
10
Increase speed