Usb Charging Port; Battery Charge Level Indicator - SNOWJOE 24V-X4-SB21-CT Manual Del Operador

2. Use the 3 discharge chute screws to secure the discharge
chute assembly to the gear plate as shown. Tighten with the
provided hex key (Fig. 5).
Fig. 5
Screws
Gear plate
Battery Pack Operation
The equipment is powered by 4 lithium‑ion batteries.
The battery packs are completely sealed and maintenance free.
TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless snow blower you will
need four batteries and a charger from the 24V iON+
System. See page 17 for battery and charger options and
specifications, or for more information visit snowjoe.com.
m
WARNING!
The cordless snow blower can only be
powered by four of the batteries together. One battery cannot
provide sufficient power to the tool. Make sure to use four
batteries of the same voltage and the same capacity. Using the
tool with batteries of different capacities will cause damage to
the batteries.

Battery Charge Level Indicator

The battery packs are equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
All 3 level monitoring LEDs are lit: Battery charge level
•
is high.
2 level monitoring LEDs are lit: Battery charge level is
•
decreasing. Stop work as soon as possible.
1 level monitoring LED is lit: Battery is flat. Stop work
•
IMMEDIATELY and charge the battery. Otherwise, the
battery's service life will be greatly shortened.
Discharge chute
assembly
7
•
Lights Light Indicators
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
NOTE: If the charge level button does not appear to be working,
place the battery pack on the charger and charge as needed.
NOTE: Immediately after using the battery packs, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells "recover" some of their
charge after resting.

USB Charging Port

Using a USB‑C charging cable (not included), plug the USB‑C
connector into the battery. Then plug the other end of the cable
into an AC adapter (not included) for charging at an electrical
outlet (Fig. 6).
The battery indicator LEDs will illuminate to indicate charging
progress. All three LEDs will light up once the battery is fully
charged, at which point unplug the battery from the charging
cable.
Fig. 6
Charging cable
(not included)
NOTE: You may also charge the battery using other USB
devices such as computers.
NOTE: When disconnected from a power source, the USB‑C
port can also be used to charge other electronic devices such
as smartphones and tablets.
AC adapter
(not included)