SNOWJOE 24V-X4-SB21-CT Manual Del Operador página 16

Troubleshooting
m
WARNING!
Always turn the tool OFF and remove the batteries before performing any adjustments, maintenance, or repairs
to your cordless snow blower.
Problem
Unit will not 1. Batteries are flat.
start
2. Batteries are not locked in position.
3. The safety button is not depressed
1. Auger belt is wore out.
The auger doesn't
rotate while the
2. Auger belt is not assembled properly.
motor is running
Chute doesn't 1. There's no power.
rotate when
2. Too much wet snow are accumulated
pressing the
button
Snow left on 1. Worn out auger blades.
the ground after
2. Worn out scraper bar.
cleaning
Possible Cause
around the chute and preventing the
chute rotating.
1. Charge the batteries.
2. Reinsert the batteries, and try to start the
machine again.
3. Depress the safety button, and pull the switch
bar lever.
1. Change the auger belt.
2. Check the auger belt, make sure it's assembled
tightely on the rail.
1. Make sure the batteries are charged and locked in
position.
2. Clean the wet snow around the chute.
1. Replace the blades.
2. Replace the scraper bar.
16
Solution