Troubleshooting - cecotec BOLERO AGUAZERO 6400 Manual De Instrucciones

ENGLISH

9. TROUBLESHOOTING

FAULT POSSIBLE CAUSE
The dishwasher is not
plugged in
The dishwasher is
not on
Blown fuse
The programme
The water inlet tap is
does not start
closed
The door of the
dishwasher is open
Blocked water inlet
hose and filters
Blocked or twisted
drain hose
There is water
inside the
The filters are blocked
machine
The programme has
not finished yet
The dishwasher
Supply fault
stops during
washing
Water inlet fault
During the
washing The spray arm is
operation there hitting the dishes on
are knocking the lower basket
noises
78
POSSIBLE SOLUTIONS
Plug in the dishwasher
Turn on the dishwasher by pressing the power
button
Contact the official Technical Support Service
of Cecotec
Open the water inlet tap
Close the dishwasher door
Check the water inlet hose and the machine
filters and make sure they are not blocked
Check the drain hose, clean it and straighten it
Clean the filters
Wait until the programme finishes
Check the power supply
Check the water tap
Move or remove the items which are blocking
the spray arm
Incorrectly placed
tableware, the
sprayed water
does not reach this
tableware
The dishes lean over
the others
There are
There was not enough
partial food
detergent
residues on the
tableware
Incorrect washing
programme selected
Spray arms with food
residues
Blocked drain
pump and filters or
incorrectly placed
filters
FAULT POSSIBLE CAUSE
There was not enough
detergent
The rinse aid dose and/
or water softener setting
There are
are too low
whitish
stains on the
High water hardness
tableware
level
The salt compartment
cap is not correctly
closed
ENGLISH
Do not overload the baskets
Place the dishes following the instructions on
the section about loading the dishwasher
Use the correct quantity of detergent,
according to the instructions on the
programmes table
Use the information on the programmes table
to select the most suitable programme
Clean the holes on the spray arms with thin
objects
Check the drain hose and the filters are
correctly placed
POSSIBLE SOLUTIONS
Use the correct quantity of detergent,
according to the instructions on the
programmes table
Increase the rinse aid and/or water softener
level
Increase the water softener level and add
salt
Check the salt compartment cap is correctly
closed
AGUAZERO 6400 / 6400 INOX / 6400 DARK
79