Automatic Fault Warning And Procedure - cecotec BOLERO AGUAZERO 6400 Manual De Instrucciones

ENGLISH
The dry option was not
The dishes are
selected
not dry
Low rinse aid dose
The quality of the
stainless-steel tableware
is not enough
High salt level in the
washing water
The salt compartment
Rust stains on
cap is not correctly
the tableware
closed
Too much salt spilled in
the dishwasher when
filling it with salt
Poor earthing of the
electrical installation
There is
The detergent was added
detergent left
when the detergent
in the detergent
compartment was wet
compartment

10. AUTOMATIC FAULT WARNING AND PROCEDURE

PROBLEM POSSIBLE
CODE FAULT
Make sure the water inlet tap is open and the water is
Insufficient
F5 Remove the tap water inlet hose and clean the hose filter
water
If the error persists, contact the Cecotec Technical Support
80
Select a programme with a dry option
Increase the rinse aid dose
Use only tableware which is dishwasher
safe
Set the water hardness level according to
the water hardness table
Check the salt compartment cap is correctly
closed
Use a funnel to fill the salt compartment to
prevent any spilling
Seek the advice of a qualified electrician
immediately
Make sure the detergent compartment is
dry before using it.
PROCEDURE
flowing
Service
Continuous Close the tap and contact the Cecotec Technical Support
F3
water inflow
The water drain hose and the filters may be blocked
Unable to
F2
drain water
If the error persists, contact the Cecotec Technical Support
F8 Heating error Contact the Cecotec Technical Support Service
F1 Overflow
Contact the Cecotec Technical Support Service
Defective
FE electronic Contact the Cecotec Technical Support Service
board
F7 Overheating Contact the Cecotec Technical Support Service
Diverter motor
F9 Contact the Cecotec Technical Support Service
position fault
Defective
F6 Contact the Cecotec Technical Support Service
heating sensor
- It is recommended that the installation is carried out by authorised service personnel to
avoid possible risks.
- The necessary reparations must be carried out by the Cecotec Technical Support Service.
Cecotec shall not be liable for any damage derived from the procedures carried out by
unauthorised persons. If you need to replace any pieces, make sure you only use original
spare parts.
- Improper repairs or the use of non-original spare parts can cause considerable damage
and put the user at significant risk.
ENGLISH
Service
Cancel the programme
Service
Unplug the machine and close the tap
AGUAZERO 6400 / 6400 INOX / 6400 DARK
81