Frost Protection - cecotec BOLERO AGUAZERO 6000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
ENGLISH
Warning
-
To avoid water entering the door gasket and the electric components, do not use any type
of spray cleaning agent to clean the dishwashing exterior.
-
Never use abrasive cleaning agents or scouring pads in the exterior surfaces, as they can
scratch the finish. Some paper towels can also scratch or leave stains in the surface.
Filtering system
Fig. 30
1.
Main filter
2.
Coarse filter
Fine filter
3.
The filtering system retains coarse remains from the wash cycle, including foreign objects
such as toothpicks or splinters. Coarse remains may block the filters.
1.
Hold the coarse filter and turn it counterclockwise to unlock it. Lift the filter upwards and
remove it from the dishwasher.
The fine filter can be removed from the lower part of the filtering set. The coarse filter
2.
can be separated from the main filter by slightly pressing the tabs on the upper part and
pulling it.
The biggest food remains can be cleaned by placing the filter under running water. For a
3.
more complete cleaning, use a soft cleaning brush.
4.
Reassemble the filters in the reverse order of disassembly, place the filtering set again
and turn it clockwise until you reach the locking arrow.
WARNING: do not press the filters too much. Place the filters again in a safe manner;
otherwise, large remains may enter the system and cause a blockage.
WARNING: never use the dishwasher without the filters installed. Incorrect substitution
of the filter may reduce the performance level of the device and damage the tableware
and utensils.
WARNING: Do not wash any filter in the dishwasher.
NOTE: the washing effectiveness will decrease if the filter is placed incorrectly.
NOTE: the use of clean filters is necessary for the correct operation of the dishwasher.
Spray arms
Fig. 31
-
Make sure the spray arms are not blocked and there are no food remains or strange objects
sticked to them. If there is some blockage, remove the spray arms and clean them under
running water.
To remove the upper spray arm, hold the nut and turn the arm counterclockwise.
1.
2.
To remove the lower spray arm, pull the spray arm upwards.
82
3.
Clean the arms with soap and warm water and use a soft brush to clean the holes. Place
them back after rinsing them thoroughly.

Frost protection

Take frost protection measures in winter. After every washing cycle, follow these steps:
1.
Turn off the electrical power to the dishwasher from the power supply.
Turn off the water supply and disconnect the water supply hose from the water valve.
2.
Empty the water from the supply hose and from the water valve. (Use a bucket to pick up
3.
water).
4.
Connect the water supply hose again to the water valve.
Remove the filter from the bottom of the dishwasher and use a sponge to absorb the
5.
water on the drain.
After every wash
After every wash, close the device water supply and leave the door slightly open for some
minutes so moisture and odours are not trapped in the interior.
When not in use for a long time
-
We recommend running a washing cycle without any load and, next, disconnect the plug
from the mains supply, close the water supply and leave the door slightly open.
-
This will help preserve the door gaskets for more time and will prevent odours forming
inside the device.
ENGLISH
83
AGUAZERO 6000/SILVER

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bolero aguazero 6000 silver

Tabla de contenido