Technical Specifications; Disposal Of Old Electrical Appliances; Technical Support And Warranty; Copyright - cecotec BOLERO AGUAZERO 6000 Manual De Instrucciones

ENGLISH
Codes Problem
E1 Greater inlet time.
E3 The desired temperature is
not reached.
E4 Overflow.
Ed Failure of communication
between the main printed
circuit board and the main
printed circuit board of the
display.
Warning
- If an overflow occurs, turn off the main water supply before contacting the Technical
Service.
- If there is water in the base due to overfilling or a small leak, water must be removed
before running the dishwasher again.
- If there is an error code you cannot solve, seek professional help.

10. TECHNICAL SPECIFICATIONS

Technical specifications may change without prior notification to improve product quality
Reference: 02359
MODEL Bolero Aguazero 6000
dishwasher
Code
Nominal voltage
Total current
88
Possible causes
The taps are not open, or the
water inlet is limited, or the
water pressure is too low.
Heating element failure.
Some element in the dishwasher
is leaking.
Open circuit or breakage of
wiring for communication.
02360
Bolero Aguazero 6000 Silver
dishwasher
220-240 V AC, 50 Hz
10 A
Water pressure
Total power
Capacity
IPX
Manufactured in China | Designed in Spain

11. DISPOSAL OF OLD ELECTRICAL APPLIANCES

This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help to protect the environment.

12. TECHNICAL SUPPORT AND WARRANTY

Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact Cecotec official Technical Support Service at +34 963 210 728.

13. COPYRIGHT

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES,
S.L. All rights reserved. The contents of this publication may not, in whole or in part, be
reproduced, stored in a retrieval system, transmitted or distributed by any means (electronic,
mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC
INNOVACIONES, S.L.
ENGLISH
Maximum 1 MPa
Minimum 0.4 MPa
1760-2100 W
12 place settings
IPX1
AGUAZERO 6000/SILVER
89