Battery Charge Indicator; Charging Batteries - Vermeiren 2217E Manual De Instrucciones

EN
NL
5. Switching the electric device On/Off
Depending on the type of battery provided, there are two ways to switch
on/off the battery:
1. Press the battery indicator button  on the battery for 2 seconds to
switch the electric device on and off. The LED's on the operator
control will indicate the status.
2. Press the on/off switch on the side of the battery.

6. Battery charge indicator

There are two battery charge indicators:
On the battery pack (located underneath the basket, rear side of the
tricycle):
1. Press button  on the battery pack.
2. The LED's of the battery charge indicator  will indicate the
battery charge level.
Operator control (located on the handlebar, front side of the tricycle):

7. Charging batteries

WARNING
Only use the battery charger delivered with the battery.
Always check the battery for damage before charging. Press the charge indicator button for 2
seconds to switch on the battery. When no LED of the charge indicator lights up, the battery may
be damaged. When at least one, but not all LEDs of the charge indicator, is lit, then fully charge
the battery pack before using for the first time.
Do not charge or use a damaged battery, contact your specialist dealer.
5. The LED indicator on the battery charger will show the status of the charging process:
• Red
• Green - Standby / Fully Charged
6. Once the battery is fully charged, remove the battery charger from the wall socket and the
battery.
When the electric system is switched on, the battery indicator (5,
§8.1.1) will indicate the battery charge level: 1 LED = low battery, 4
LEDs = full battery.
Because of the wiring, both indications can deviate a little bit. In that
case, take the worst charge level indication.
Risk of injury
To ensure full battery capacity, completely charge the battery with the
charger before using it for the first time. The battery can be recharged at
any time on the tricycle or while removed from the tricycle.
Instructions to charge the removed battery:
1. Switch the battery/electric device off.
2. Remove the battery from the battery housing and prevent dirt or fluids
from entering the charging socket.
3. Connect the charger plug to the battery pack .
1
4. Connect the charger mains plug into the wall socket.
- Charging
2
2217E, 2219E
2022-08
1
2
1