Manufacturer's Warranty; Further Information; Originele Handleiding - Hilti NURON NCR 120-22 Manual De Instrucciones

Trouble or fault
The battery doesn't engage
with an audible click.
Red LED => lights continu-
ously and a warning tone is
emitted.
Red LED => flashes at short
intervals and a warning tone
is emitted.
Red LED => flashes at long
intervals and a warning tone
is emitted.
Red LED => lights briefly and
no warning tone is emitted.
LEDs of the battery show
nothing
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

Further information

For more information on operation,
qr.hilti.com/manual?id=02321721 &id=2321723
This link is also to be found at the end of the documentation, in the form of a QR code.

Originele handleiding

1 Informatie over de handleiding
1.1 Bij deze handleiding
• Lees voor ingebruikname deze handleiding door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze handleiding en op het product in acht
nemen.
• De handleiding altijd bij het product bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
*2321721*
Possible cause
The retaining lugs on the battery
are dirty.
Technical problem.
The state of charge of the battery
is too low to allow a complete op-
erating cycle.
Crimping / pressing pressure not
achieved (tool was used incorrect-
ly).
Product overheated.
Battery faulty.
technology,
2321721
Action to be taken
▶ Clean the retaining lugs and refit
the battery.
▶ Contact Hilti Service.
▶ Change the battery and charge
the empty battery.
▶ Make sure that the tool is used
correctly and check the crimped
/ pressed part if unsure.
▶ Allow the product to cool down.
▶ Contact Hilti Service.
environment and recycling, follow this link:
Nederlands 27