Manufacturer's Warranty; Further Information; Originele Handleiding; Informatie Over Documentatie - Hilti DX 6 Manual De Instrucciones

Malfunction
The cartridge strip melts
A cartridge detaches itself
from the cartridge strip
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 C.I.P. test confirmation
The following applies to C.I.P. member states outside the EU and EFTA judicial areas: The Hilti DX 6 has
been system and type tested. As a result, the tool bears the rectangular PTB approval mark showing
approval number S 1035. Hilti thus guarantees compliance with the approved type.
13

Further information

For more information on operation,
qr.hilti.com/manual?id=2232121&id=2232122&id=2232124&id=2253453
This link is also to be found at the end of the documentation, in the form of a QR code.

Originele handleiding

1

Informatie over documentatie

1.1

Over deze documentatie

• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
• De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
36 Nederlands
Possible cause
Fastening tool was pressed against
the working surface for too long.
Fastener driving rate too high (fas-
tening tool overheated).
Fastener driving rate too high (fas-
tening tool overheated).
technology, environment and recycling,
Action to be taken
▶ Remove cartridge strip and
insert a new cartridge strip
instead.
▶ Fire the fastening tool sooner
after pressing it against the
working surface.
▶ Stop using the tool immediately.
▶ Remove cartridge strips and
allow the fastening tool to cool
down.
▶ Do not exceed the recom-
mended maximum fastener
driving rate (see the section
headed "Technical data").
▶ Stop using the tool immediately.
▶ Remove cartridge strips and
allow the fastening tool to cool
down.
▶ Do not exceed the recom-
mended maximum fastener
driving rate (see the section
headed "Technical data").
follow this link:
2232121
*2232121*