Switching On / Off - HOLZMANN MASCHINEN PJ 100A Manual De Instrucciones

 The center of the groove must be run from the workpiece outer edge at least 50 mm.
 With several wood joints 100 mm - 150 mm groove spacing hold.
Only for corner joint and center wall connection
 The vertical workpiece clamp to the workbench.
Only with mitred
 Clamp a workpiece with the mitered edge up on the workbench.
Only for frame connections and the longitudinal and transverse links
A workpiece clamp to the workbench.
 Set the groove depth according to the size of the timber connector to be used.
 See the table in the section "Setting the groove depth 12.1.3".
 Adjust the angle stop on the cutting tool and workpiece center.
 Align the center mark on the base plate on the pencil line on the workpiece.
 Turn on the power and move it forward immerse the cutting tool into the workpiece.
 After reaching the preset cutting depth the unit carefully drive back to the starting
position.
Only for corner joint and center wall connection
 Clamp the horizontal workpiece at the workbench
The biscuit jointer machine is suitable for joints in solid wood, plywood, particle board, fiberboard,
Plexiglas and artificial marble, etc. 8 mm (5/16 in.) thickness.

11.4.2 Switching on / off

 Never use the spindle lock during starting or when the machine is working.
 Always make sure that the slide switch is working properly before connecting the machine
and when you press the rear panel to the "OFF" position returns.
 The switch can be locked to make work easier for extended use in the "ON" position.
 Be careful, when you lock the switch in the "ON" position, and hold the tool firmly.
 To switch the unit to switch to the position "I" (ON) push. For continuous operation, the
switch into place by pressing its front.
 To turn off the machine, press the rear of the slide switch and then the switch to the "O
(OFF)" push.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
20
PJ 100A