HOLZMANN MASCHINEN PJ 100A Manual De Instrucciones página 17

 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
 Use the power tool, accessories and tool bits etc. in accordance with these instructions,
taking into account the working conditions and the work to be performed. Use of the power
tool for operations different from those intended could result in a hazardous situation.
Additional safety instructions:
 Sawdust and splinters must not be removed while the machine is running.
 Do not use cutting discs or circular saw blades in the machine.
 Protect blades against shocks and impacts
 Only use properly sharpened blades, otherwise increased culling forces will shatter the work
piece.
 Before use, inspect the blade for any damage. Do not use blades that are cracked, ripped or
otherwise damaged
 Make sure that the work piece is sufficiently supported or clamped. Keep your hands away
from the surface to be cut
 Use the machine only with the auxiliary handle.
 When blades have to be mounted on the thread of the spindle, make sure that the spindle
has sufficient thread
 Make sure that the blade has been mounted and fastened properly. Do not use reducing rings
or adapters to make the blade fit properly.
 Apply the machine to the work piece only when the machine is switched on.
 When working with the machine always hold the machine firmly with both hands and provide
for secure distance.
 Always wear safety goggles and hearing protection. If desired or required also use another
protection for example an apron or helmet
 Always disconnect the plug from the socket before carrying out any work on the machine,
only plug in when the machine is switched off
 Keep mains lead clear from working range of the machine. Always lead the cable away
behind you.
 The base plate must not be clamped down while the blade is extended. Lowering and raising
the blade must be a smooth operation.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 17
PJ 100A