Cleaning; Maintenance - Wayscral Kickway L1 Manual De Instrucciones

I.

Cleaning

Check that the power supply and charging cable of the Kickway
•
L1 scooter have been disconnected.
Clean your Kickway L1 scooter with a soft, dry cloth.
•
WARNING!
•
that it is protected from splashes. However, it should not be
immersed in or sprayed with water. Therefore, never clean the
Kickway L1 scooter with high-pressure water jets or immerse it
in any liquid.
Do not allow water or other liquids to enter into the Kickway L1
•
scooter, as this may cause irreversible damage to the electronic
components.
Your product would then be excluded from the warranty.
•
Cleaning and user maintenance of the scooter must not be
•
carried out by children without supervision.
Never use alcohol, gasoline or any other corrosive chemical to
•
clean your scooter. This could seriously damage the appearance
and structure of your scooter.
II.

Maintenance

General recommendations
Do not make any modifications that are not specified by the
•
manufacturer.
Contact an approved workshop, such as Norauto/ATU/Auto 5.
•
Wheel and brake system maintenance:
Remember to apply lubricating oil regularly to both ends of the
•
brake cable to ensure its long life and proper functioning.
Check the front and rear wheels and hub carefully before using
•
the scooter. The wheels must not be damaged or punctured.
Check the brake carefully before using the scooter.
•
In the event of a problem, contact the after-sales service to have
•
the wheels replaced.
Your Kickway L1 scooter is IPX4 certified. This means
75