Equipment; Display And Controls - Hupfer KWP Manual De Instrucciones

Operating Instructions
EN
3.2

Equipment

3.2.1 Display and controls

The display and controls are mounted as a unit in the same structure
as the hot and cold plate; the position can be freely determined during
installation.
Controls and display for hot and cold plate
1 Main switch
2 Increase set temperature, "Heating
mode"
3 Reduce set temperature, "Heating
mode"
4 Setting button, "Heating mode"
5 Display, "Heating mode"
The unit is switched off completely via the main switch and the
operating mode (heating mode or cooling mode) is selected.
The display shows the current actual temperature for each operating
mode. When the temperature is set, the display shows the required
temperature.
The required temperature is set using the controls on the displays.
If the hot and cold plate is used together with a permanently installed
heated lamp gantry, the heated lamp gantry can be connected and
operated via the controls. In this case, the controls can also be
installed in the heated lamp gantry.
Hot and cold plate
6 Display, "Cooling mode"
7 Setting button, "Cooling mode"
8 Reduce set temperature, "Cooling
mode"
9 Increase set temperature, "Cooling
mode"
Page 8