Start-Up; Pairing; Direct Pairing With A Homematic Ip Device - HomeMatic HmIP-eTRV-CL Instrucciones De Montaje

5

Start-up

5.1

Pairing

Please read this entire section before starting the pairing proce-
dure.
You can either pair the radiator thermostat directly with one or more
Homematic IP devices or add the device to the Homematic IP Access
Point (HmIP-HAP). After direct pairing, configuration must be done di-
rectly on the device. After pairing with the access point, configuration is
done via the Homematic IP app.
5.1.1

Direct pairing with a Homematic IP device

You can directly pair the Homematic IP Radiator Thermostat with
other Homematic IP Radiator Thermostats (HmIP-eTRV-CL or
HmIP-eTRV-B), the Homematic IP Window / Door Contact with
magnet (HmIP-SWDM (HmIP-SWDM-2) and/or the Homematic IP
Wall Thermostat (HmIP-WTH-B/HmIP- WTH-B-2).
Please make sure you maintain a distance of at least 50 cm between
the devices during pairing.
You can cancel the pairing procedure by briefly pressing the menu
button (D). This will be indicated by the device LED (D) lighting up
red.
To connect the device with another Homematic IP device, the pairing
mode of both devices must be activated. To do this, proceed as follows:
• Open the battery compartments by pulling the cover (F) first
downwards and then forwards (see figure 3).
• Pull the insulation strip out of the battery compartment.
• Press and hold the menu button (D) until the configuration menu
opens.
• Select "PAIR" using the plus and minus buttons (C + E).
Start-up
45