Changing The Pin; Operation - HomeMatic HmIP-eTRV-CL Instrucciones De Montaje

Operation

6.11

Changing the PIN

To change the assigned PIN, proceed as follows:
Press and hold the menu button (D) for approx. 2 seconds to
•
open the configuration menu.
Select "PIN" using the plus and minus buttons (C + E).
•
• Confirm with the menu button.
• "OLD" appears in the display. Confirm with the menu button to
change the existing PIN. The factory setting for the PIN is "0000".
• "0000" appears in the display. Enter the first digit of the existing
PIN using the plus and minus buttons and confirm with the menu
button to switch to the next digit.
• Now enter the second, third and fourth digits of the PIN in the
same way and confirm each entry with the menu button.
• "NEW" appears in the display. Confirm with the menu button to
enter the new PIN.
• "0000" appears in the display. One after another, enter the digits
of the new PIN using the plus and minus buttons and confirm
with the menu button.
"SAFE" appears in the display. The new PIN has been saved. The device
switches back to the standard display.
7 Operation
If the radiator thermostat is in standby mode (display lighting off),
you must press a button (C, D or E) on the radiator thermostat be-
fore operation in order to activate it (display lighting on).
After pairing and mounting have been performed, simple operations are
available directly on the device.
• Temperature: Press the plus (C) or minus button (E) to manually
change the radiator temperature. In automatic mode, the man-
ually set temperature will remain the same until the next point
at which the schedule changes. Afterwards, the defined heating
schedule will be activated again. During manual operation, the
temperature remains activated until the next manual change.
60