Craftsman CMXGZBF450568 Manual De Instructiones página 10

ENglISh
APPenDiX B
ASSemBLe tO SLAtWALL fOr StOrAge
(OPtiOnAL)
This section is applicable if you have a slat wall for storing the
tool rack.
Step 1 (figure 19)
1. Slide the wall anchor assembly (15) into a slot on the
wall rack at the desired height.
2. Slide the wall storage bracket (16) into the slot on the
wall rack just above the wall anchor assembly, so that
the bolt and slot line up as shown.
3. Repeat steps 1 and 2 on other side of the wall rack.
4. Secure each wall storage bracket (16) with a wing
knob (V) and hand tighten.
Fig. 19
16
V
Step 2 (figure 20)
1. Insert a hex bolt (W) bolt with large washer (B) and
spacer (C) into each wall storage bracket as shown.
2. Secure each bolt with a hex nut (F) and tighten.
Fig. 20
W
8
15
B C
F
Step 3 (figure 21)
1. To hang the tool rack for storage, insert the bag mount
brackets (8) into a slot on the wall rack below the wall
storage brackets as shown.
2. Loop the support cables over the washers on the wall
storage brackets.
Note: You many need to adjust the location of the
bag mount brackets to properly support the tool rack.
Fig. 21
8