Makita GPK01 Manual De Instrucciones página 11

5. Loosen the screws on the set plate one turn to
disengage the adjusting plate.
Fig.16
► 1 . Screws 2. Set plate 3. Adjusting plate
6.
Clean out all the wood chips and foreign matters
adhering to the set plate (with adjusting plate) and mini
planer blade.
7. Set the mini planer blade onto the blade gauge,
aligning its cutting edge along the guide wall on the
blade gauge horizontally.
8.
Place the set plate (with adjusting plate) over the
mini planer blade, aligning the guide ridges on the set
plate with guide grooves on the mini planer blade.
7
2
1
Fig.17
► 1 . Mini planer blade 2. Blade gauge 3. Cutting edge
4. Guide wall 5. Set plate (with adjusting plate)
6. Guide ridge 7. Guide groove
9.
Push the adjusting plate forwards until its position-
ing guide neatly and entirely fits along the rear side wall
of the blade gauge.
2
3
1
5
4
10. Hold the adjusting plate where it is and tighten the
screws to secure it in place.
2
3
1
Fig.18
► 1 . Adjusting plate 2. Set plate 3. Screw
6
4. Positioning guide 5. Rear side wall 6. Blade
gauge
11. Slip the positioning guide of the adjusting plate
into the guide groove in the drum, and then place the
drum plate over the set plate (with adjusting plate).
3
Fig.19
► 1 . Positioning guide 2. Adjusting plate 3. Guide
groove 4. Drum 5. Drum plate 6. Set plate
7. Installation bolt
11 ENGLISH
4
6 5
7
5
2
1
6
4
3