Makita GPK01 Manual De Instrucciones página 18

Using chamfering rules
Optional accessory
1. Slide the edge fences in the chamfering rules
inwards until they come in contact with the corner walls
of the workpiece.
2.
Secure the edge fences in place with the thumb
screws.
3. Perform planning operation by moving the tool
with the whole edge fences sliding along the corner
walls of the workpiece.
3
2
Fig.43
► 1 . Chamfering rule 2. Edge fences 3. Thumb screw
NOTE: For large chamfers, make many passes of
planning, starting from small chamfering to larger
chamfering, as shown in the figure.
3
Fig.44
► 1 . Edge fences 2. Small chamfering 3. Large
chamfering
1
2
1
2
3
18 ENGLISH
WIRELESS ACTIVATION
FUNCTION
What you can do with the wireless
activation function
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
Fig.45
To use the wireless activation function, prepare follow-
ing items:
• A wireless unit (optional accessory)
• A vacuum cleaner which supports the wireless
activation function
The overview of the wireless activation function
setting is as follows. Refer to each section for detail
procedures.
1.
Installing the wireless unit
2.
Tool registration for the vacuum cleaner
3. Starting the wireless activation function
Installing the wireless unit
Optional accessory
CAUTION:
Place the tool on a flat and stable
surface when installing the wireless unit.
NOTICE:
Clean the dust and dirt on the tool
before installing the wireless unit. Dust or dirt
may cause malfunction if it comes into the slot of the
wireless unit.
NOTICE:
To prevent the malfunction caused by
static, touch a static discharging material, such
as a metal part of the tool, before picking up the
wireless unit.
NOTICE:
When installing the wireless unit,
always be sure that the wireless unit is inserted
in the correct direction and the lid is completely
closed.