Makita GAG13 Manual De Instrucciones página 12

Installing wire cup brush
Optional accessory
CAUTION:
Do not use wire cup brush that is
damaged, or which is out of balance. Use of dam-
aged brush could increase potential for injury from
contact with broken brush wires.
Fig.11
► 1. Wire cup brush
Installing wire wheel brush
Optional accessory
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
ALWAYS use guard with wire
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
Fig.12
► 1. Wire wheel brush 2. Wheel guard
Installing or removing X-LOCK
wheel
the X-LOCK holder during operation. Make sure
that the X-LOCK wheel has stopped completely
when removing it. Otherwise, the X-LOCK wheel
comes off from the tool and may cause serious injury.
with the X-LOCK logo. This tool is dedicated to
X-LOCK.
1
The maximum clamping gauge of 1.6 mm (1/16") can
only be guaranteed with original X-LOCK wheels.
Use of any other wheels may lead to insecure clamp-
ing, and cause the clamp tool to come loose.
immediately after operation. It may be extremely
hot and could burn your skin.
and holder of the tool are not deformed and are
free from dust or foreign matters.
holder while installing or removing the X-LOCK
wheel. It may pinch your finger.
release lever while installing the X-LOCK wheel. It
may pinch your finger.
NOTE: No additional parts such as inner flanges
or lock nuts are required to install or remove the
X-LOCK wheels.
1.
1
2
Fig.13
► 1. Catch 2. Release lever
12 ENGLISH
WARNING:
Never actuate the release lever of
CAUTION:
Use only original X-LOCK wheels
CAUTION:
Do not touch the X-LOCK wheel
CAUTION:
Make sure that the X-LOCK wheel
CAUTION:
Do not put your finger near the
CAUTION:
Do not put your finger near the
To install the X-LOCK wheel, make sure that both
catches are in the unlocked position.
If not, push the release lever from A side to lift B
side, then pull the release lever from B side as
illustrated. The catches are set in the unlocked
position.
1
2
A
B