Stop Ice Cube Production; Control Lamp (Ice Cube Container Full); Control Lamp (Water Refill); Cleaning And Maintenance - Profi Cook PC-EWB 1187 Manual De Instrucciones

- The first few ice cubes will be small depending on the
water temperature and ambient temperature. The ice
cubes will only grow larger in the following cycle.
- Due to fast freezing the ice cubes can look "milky".
This is the air trapped in the water and does not influ-
ence the quality of the ice cubes.
6. Keep the ice cube container closed during ice cube
making. An ice cube making cycle lasts between 8 and
12 minutes.

Stop Ice Cube Production

Touch ON / OFF on the display to stop ice cube production.
- If operation is manually interrupted, water which is no
longer needed is fed back to the water tank. Only then
will the appliance stop. Half-finished ice cubes remain
suspended on the cooling rods. As soon as it is suffi-
ciently thawed, it will fall off and drop into the ice cube
container.
Control Lamp (Ice Cube Container Full)
As soon as the ice cube container is full, the sensor stops
production.
WARNING:
• Always switch off the appliance and disconnect the mains plug
from the socket before cleaning.
• Never immerse the appliance in water to clean it. Doing so may
lead to electric shock or fire.
CAUTION:
• Do not use wire brushes or other abrasive implements.
• Do not use harsh or abrasive cleaning agents.
• Do not use chemicals, acids, petrol or oil products.
• For hygienic reasons exchange the water in the tank
after 24 hours.
• Remove the ice cube container after use. If the water
tank remains open no mould or bacteria can form.

Ice Cube Container

Remove the ice cube container. Clean it in warm rinse water
with a little hand dishwashing liquid. Rinse with clean water.

Housing and Interior

• Clean housing and interior with a damp cloth.
• Use a diluted solution of vinegar and water.
PC-EWB1187_new - SH separat

Cleaning and Maintenance

The control lamp then lights up and you hear several
signal tones. The appliance switches into standby mode.
• Remove the ice cubes with the supplied ice cube scoop.
When removing the ice cube container, some water will
drip through the holes onto the floor.
• The control lamp turns off and a few moments later
ice cube production starts again.
Control Lamp (Water Refill)
The control lamp turns on if the water tank is nearly empty
and a beep tone sounds. Ice cube production is automati-
cally halted.
1. Empty the ice cube container.
2. Refill with potable water as described in chapter "Making
Ice Cubes". Since there may still be water in the appli-
ance, check the FULL mark in the water tank.
3. Close the ice cube container.
4. Touch ON / OFF two times on the display to resume the
ice cube production. The control lamp

Drain Residual Water

Drain the residual water if the appliance is not in use for a
longer period of time. Rest the appliance on a table edge.
Take a bowl and hold it under the drainage opening for the
residual water.
• Remove the dividing wall and pull the closure out of the
bottom.
• After the residual water has been drained, put the clo-
sure back into the opening and replace the dividing wall.

Storage

• Clean the appliance as described and allow it to dry
completely.
• We recommend that you keep the appliance in the
original packaging if you do not intend using it for long
periods.
• Always keep the appliance out of the reach of children in
a dry, well-ventilated place.
turns off.
11
27.09.22