Warning; Caution; Figure B; Warnings For The Use Of The Appliance - Profi Cook PC-EWB 1187 Manual De Instrucciones

Figure B

Shown on
Meaning
Display
MODE
Setting the size of the ice cubes
Start making ice cubes / interrupt /
ON / OFF
finish making ice cubes
S Small ice cube size
M Medium ice cube size
L Large ice cube size
Ice cube container full
Water refill
• Rotating display: Ice cube being made
• Flashing display: Fault
Blockade

Warnings for the Use of the Appliance

WARNING:

The refrigerant circuit of the appliance uses the refrig-
erant isobutane (R600a), a flammable natural gas with
high environmental sustainability. When transporting and
installing the appliance, prevent the appliance from falling
down. The refrigerant circuit must not get damaged.

CAUTION:

Please observe a waiting period of 2 hours before initial
operation and after moving the appliance for the refriger-
ant to settle. Otherwise the compressor can be damaged.

If the Refrigerant Circuit is Damaged

• Open flames and ignition sources must be avoided.
• Disconnect the mains plug.
• Ventilate the room in which the appliance is installed.

Notes for Use

Location

• Place the appliance on a stable, horizontal, water-resist-
ant and level surface. Maintain a gap of at least 15 cm to
walls or objects.
• Do not place the appliance on or directly next to heat
sources such as ovens, radiators, etc.

Electrical Connection

1. Insert the appliance plug of the power supply cord into
the socket on the back of the appliance.
10
PC-EWB1187_new - SH separat
2. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the appli-
ance. You can find this information on the nameplate.
3. Connect the appliance to a properly installed wall outlet.
A signal tone will sound. The appliance is in standby
mode.

Standby (Standby Mode)

• The buttons ON / OFF and MODE are illuminated in the
display.
• The ice cube size that was last set is flashing.

Using the "Touchscreen"

The appliance is operated through the touchscreen. Touch
the displayed buttons ON / OFF and MODE gently with your
finger to execute the functions.

Ice Cube Size

You may choose between 3 sizes:
- small (S)
- medium (M)
- large (L)

Eco Save (Power Saving Mode)

Once the ice cube container is full the appliance switches
into standby mode.
You benefit from better safety and lower energy consumption.

Operation

Making Ice Cubes

1. Refer to figure A on page 3. Pull the ice cube container
about half way.
2. Using the supplied measuring beaker as a guide, pour at
least 0.8 litres drinking water, to a maximum of 1.7 litres,
into the water tank through the ice cube container.
- You can also pull out the ice cube container com-
pletely. By doing so you pour the drinking water
directly into the water tank.
- The FULL mark can be found on the water tank.
- For best results, aim for a water temperature of
between 7 °C and 20 °C as well as an ambient tem-
perature of between 16 °C and 25 °C.
- If you want clear ice cubes, use chilled drinking water
which has firstly been boiled.
3. Close the ice cube container.
4. Start ice cube production by touching ON / OFF on the
display. The control lamp
that was last set is flashing
5. Touching MODE on the display allows you to select the
desired ice cube size.
- For hygienic reasons do not use the ice cubes from
the first cycle.
rotates. The ice cube size
27.09.22