ASSEMBLY
STEP 3
Corner Tube
3
10
with Foam (x2)
STEP 4
4
Curved Tube
with Foam (x2)
Bent side
Insert the corner tubes with foam (3) into the sleeve as shown, and
secure on each side using two self-tapping screws (10).
Note: One end of the corner tube has one hole, and the other end has
two holes. You are connecting the end with one hole.
Self-tapping
Screws (x2)
Two holes
If you want the hoops to face inwards: Insert the curved tube
(4) into the sleeve, making sure the bent side curves toward the
back. Secure using two self-tapping screws (10). If you want the
hoops to face outwards: Insert the curved tube into the sleeve,
making sure the bent side curves towards the front. Secure
Self-tapping
10
using two self-tapping screws.
Screws (x2)
Bent side
(10)
(3)
(10)
(4)
8
(10)
(3)
(10)
(4)