SHOWJOE 24V-SUV1 Manual Del Operador página 8

6. Screw both sprockets into the two remaining wheels using
three ST4 x 12 round head screws for each wheel (Fig. 6).
Fig. 6
Sprocket
7. Slide a motor, a wheel, a washer and a lock nut onto either
side of the rear axle. Repeat for the other side and use the
pair of socket wrenches to tighten both lock nuts at the
same time before installing the hub caps (Fig. 7).
NOTE: The motors are marked (L) for left and (R) for right
to indicate the side of the axle they need to be installed at.
Fig. 7
Axle
Motor
Wheel
8. Connect the motor cables to the motor controller (Fig. 8).
ST4 x 12 round
head screws
Washer
Lock
Nut
Hub cap
Fig. 8
Motor
9. Place the seat over the motor compartment and secure
it on both corners using the two remaining ST4 x 12 truss
head screws (Fig. 9).
Fig. 9
Seat
ST4 x 12
truss head
screws
10. Connect the steering wheel cable before installing the
steering wheel onto the steering column (Fig. 10).
Fig. 10
Steering
wheel cable
8
Motor
Steering wheel