SHOWJOE 24V-SUV1 Manual Del Operador página 9

11. Connect the rear roll bar frame with both side roll bar
frames using two ST3 x 12 screws. Then push the entire
roll bar into the four holes next to the seat (Fig. 11).
Fig. 11
Rear roll
bar frame
ST3 x 12
screws
Side roll
bar frame
12. Unscrew the two screws on each side of the dash and
then install both doors onto the ride-on SUV (Fig. 12).
Fig. 12
Door
13. Push the metal pivot arm of the door into the slot adjacent
to the dash. Then secure both doors with the screws
removed earlier (Fig. 13).
Fig. 13
Pivot arm
14. Insert the windshield and side-view mirrors into their
respective sockets (Fig. 14).
Fig. 14
Windshield
Operation
1. Unfasten both latches to open the hood. Insert the battery
into the battery compartment (Fig. 15).
Fig. 15
Screw
2. Push the on/off button to turn on the ride-on SUV.
Driving
1. Fasten the 4-point racing harness.
2. Use the gear shift to toggle between the driving modes:
• Top – Drive
• Middle – Park
Screw
• Bottom – Reverse
3. Step on the gas pedal to accelerate. Release the gas
pedal to brake. Use the steering wheel to turn.
9
Battery
Side-view
mirror
Latch