Installation
Over a laundry sink:
B
*
22
English
DV6900B_LED_WEB_Heatpump_EN.indd 22
2. Insert one end of the accessory hose
3. Position the other end (the outlet)
A
1. Make sure to place the end of the
2. To bend the accessory hose so that it
A
Do not extend the drain hose by
connecting another hose to it. Water can
leak from the connected area. If you need
more length, use a longer drain hose.
B
C
ln a standpipe or laundry tub
C
The laundry tub (B) or standpipe (C) must
be no higher than 35.4 In (90 cm).
D
Make sure the drain hose and the
standpipe are not airtight.
E
D: Hose retainer / E: Tie straps
(the long drain hose) into hole (A).
over a laundry sink or connect it to the
drain pipe of a laundry sink. See the
instructions below or on the next page.
accessory hose no more than 3 ft. (90
cm) above the bottom of dryer.
hooks over the edge of the sink, use
the supplied plastic hose guide (B) and
secure the guide to the wall with a hook
or to the tap with a piece of string.
Assemble the drain hose (A) and the
hose guide (B) and fix them with the
cable-tie (C).
CAUTION
NOTE
2022/6/23 16:15:49