Important Safety Instructions - HOMCOM 820-348V70 Instrucciones De Ensamblaje

Please read and understand this entire manual before attempting to assemble, operate or install this
product.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: POTENTIAL ELECTRICAL HAZARD IF NOT ADHERED TO. When using electrical
appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and
injury to persons, including the following:
● The heater must be plugged into a 220-240V, 50Hz circuit. Do not plug anything else into the same
circuit. If unsure that your home meets this specification, consult a certified electrician prior to use. Risk
of fire, overheating, malfunction, property damage, injury or death may result if not adhered to!
● Do not connect the heater to extension cords, surge protectors, timers, direct breakers or an outlet with
other appliances connected to the same outlet. Risk of fire, overheating, malfunction, property
damage, injury or death may result if not adhered to!
● The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles
(certain models) or wheels to move this heater.
● Keep combustible materials, such as furniture, pillows, bedding, paper, clothes and curtains at least 3
ft (0.9m) from the front, sides and rear of the heater.
● Extreme caution is necessary when any heater is used by or near children, pets, persons with
disabilities or when the heater is left operating unattended.
● Always unplug the heater when not in use.
● Do not operate any heater with a damaged cord or plug, or after the heater malfunctions, has been
dropped or damaged in any manner. Contact the manufacturer for resolution options.
● Do not use outdoors. Exposure to rain, snow, sun, wind or extreme temperatures may cause the heater
to become a safety hazard.
● Do not use this heater in bathrooms, laundry areas and similar indoor locations. Do not use in any
location that uses GFCI outlets.
● Never place the heater where it could fall into a bathtub or other water containers.
● Do not run the cord under carpet. Do not cover the cord with throw rugs, runners or similar coverings.
Keep the cord away from congested areas, so it cannot be tripped over.
● The heater must be plugged into a wall outlet that is a dedicated circuit with a minimum 15-amp rating.
● When unplugging the heater, turn the power button to the 'OFF' position, then remove the plug from the
wall outlet.
● Do not let foreign objects enter or block any ventilation or exhaust opening – this could cause electric
shock, fire or damage to the heater.
● Allow at least 0.9m of unobstructed space to the front and rear of the heater for maximum heat, air and
ventilation flow.
● A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint or
flammable liquids are used or stored. Do not use flammable solvents to clean this heater. Keep the
heater dry at all times.
● Do not use abrasive solvents to clean the heater – this could damage the finish or casing.
● To prevent a fire, do not block air intakes or the exhaust in any manner. Do not use on soft surfaces,
such as beds, where opening could be blocked.
● Always plug heaters directly into a wall outlet/receptacle. Never use an extension cord or relocatable
power tap (outlet/power strip).
SAVE THESE INSTRUCTIONS
4