Operating The Saw; Battery Pack And Charger - Oregon CS300 Manual De Instrucciones

OPERATING THE SAW

OPERATING THE SAW

BATTERY PACK AND CHARGER

WARNING: DO NOT CHARGE THE
BATTERY PACK IN THE RAIN.
BATTERY PACK LED CHARGE-LEVEL
INDICATOR
The lithium ion battery pack is equipped
with an LED charge-level indicator . To test
the charge level of the battery pack, press
the indicator button on the battery pack's
face (Fig . 19) .
No lights: recharge .
One steady green light:
less than 25% charged .
Charge battery pack before use .
Two steady green lights:
26–50% charged .
Three steady green lights:
51–75% charged .
Four steady green lights:
76–100% charged .
FIG. 19
INDICATOR BUTTON
INDICATOR LIGHTS
CONNECTING THE CHARGER
If the charger includes a separate power cord,
connect the charger cord to the charger and
to the proper electrical outlet (Fig . 20) .
FIG. 20
20
OREGON® Cordless Tool System
CHAIN SAW MODEL CS300
Only use the cord set that was supplied
with the charger . At first use, verify that
the plug type matches the receptacle .
CHARGER LED CHARGE-STATE
INDICATOR
The battery charger is equipped with
an LED charge-state indicator that
indicates the state of charging as well
as conditions that may delay or prevent
charging (Fig . 21) .
Note: Until a battery pack is inserted, no
lights will be visible .
Blinking orange light: a fault
condition exists . There are
several potential causes . See
"Troubleshooting" in this manual .
Steady orange light: the battery
pack temperature is beyond the
acceptable range (32°F/0°C to
104°F/40°C) . Allow the battery pack
to reach the acceptable
temperature range before
charging . The pack may be left on
the charger as the temperature
adjusts . Charging will begin when
the proper temperature is
reached .
FIG. 21
Blinking green light: battery pack
is charging .
Steady green light: battery pack is
ready for use .
AA 1214 - F/N 573259