Operating The Saw - Oregon PowerNow CS250 Manual De Instrucciones Original

OREGON® PowerNow™
CHAINSAW MODEL CS 250

operating the saW

battery pack and charger
battery pack led charge-level
indicator
The lithium ion battery pack is equipped
with an lED charge-level indicator . to test
the charge level of the battery pack, press
the indicator button on the battery pack's
face (Fig. 5).
no lights: recharge .
One steady green light:
less than 25% charged. Charge
battery pack before use.
Two steady green lights:
26-50% charged.
Three steady green lights:
51-75% charged.
Four steady green lights:
76-100% charged.
Fig. 5
indicator button
indicator Lights
connecting the charger
connect the charger cord to the charger
and to the proper electrical outlet
(Fig . 6) .
Fig. 6
AA 0612 - F/N 551309
Only use the cord set that was supplied
with the charger. At first use, verify that
the plug type matches the receptacle.
charger led charge-state
indicator
The battery charger is equipped with an
lED charge-state indicator that alerts
you to the state of charging, as well as
conditions that may delay or prevent
charging (Fig . 7) .
Note: Until a battery pack is inserted, no
lights will be visible .
Blinking orange light: a fault
condition exists. There are
several potential causes . see
"troubleshooting" in this manual .
Steady orange light: the battery
pack temperature is beyond the
acceptable range (0°c/32°F to
40°C/104°F). Allow the battery
pack to reach the acceptable
temperature range before
charging. The pack may be left on
the charger as the temperature
adjusts. Charging will begin
when the proper temperature is
reached .
Fig. 7
Blinking green light: battery pack
is charging .
Steady green light: battery pack
rEaDy For usE .
operating the saW
17