Maintenance And Storage - STERWINS EHT2-50.31 Manual De Instrucciones

2. SAFETY INSTRUCTIONS

Maintenance and storage

If the supply cable is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
If the carbon brushes need to be replaced, have this done by a qualified
repair person (always replace the two brushes at the same time).
1. Disconnect the product from the power supply(i.e. remove the plug
from the power supply) and check for damage after use.
2. Disconnect the product from the power supply (i.e. remove the plug
from the power supply)before carrying out maintenance or cleaning
work.
3. Use only the manufacturer' s recommended replacement parts and
accessories.
4. Inspect and maintain the product regularly. Have the product repaired
only by an authorised service centre or similar qualified specialist.
5. When not in use, store the product out of the reach of children.
6.Servicing by manufacturer or agent.
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the time of
operation, use low-vibration and low-noise operating modes as well as
wear personal protective equipment.
Take the following points into account to minimise the vibration and
noise exposure risks:
1. Only use the product as intended by its design and these instructions.
2. Ensure that the product is in good condition and well maintained.
3. Use correct attachments for the product and ensure they are in good
condition.
217
EN