STERWINS YT5309-04 Instrucciones De Montaje página 56

Problem
1. Product does not start 1.1. Not connected to power supply
2. Product does not reach
full power
3. Unsatisfactory result
4. Excessive vibration or
noise
Disposal and recycling
The product comes in a package that protects it against damage during shipping. Keep the package until
you make sure that all parts have been delivered and the product operates properly. And then recycle the
package.
CAUTION! This product shall not be discarded with household waste but that it shall be returned
to a collection system which conforms to the European WEEE Directive. Contact your local
authorities or stockist for advice on recycling. It will then be recycled or dismantled in order to
reduce the impact on the environment. Electric and electronic equipment can be hazardous for
the environment and for human health since they contain hazardous substances.
TROUBLE SHOOTING
Possible cause
1.2. Power cord or plug is defective
1.3. Other electrical defect to the
product
2.1. Extension cord not suitable for
operation with this product
2.2. Power source (e.g. generator)
has too low voltage
2.3. Air vents are blocked
3.1. Blade is worn/damaged
3.2. Thickness of branches exceeds
capacity
4.1. Blade is damaged
4.2. Bolts/nuts are loose
55
Solution
1.1. Connect to power supply
1.2. Have it checked by a
specialist electrician
1.3. Have it checked by a
specialist electrician
2.1. Use a proper extension cord
2.2. Connect to another power
source
2.3. Clean the air vents
3.1. Have it replaced with new
one
3.2. Only cut branches
complying with the
capacity
4.1. Have it replaced with new
one
4.2. Tighten bolts/nuts
EN