STERWINS EPS2-20.3 Manual De Instrucciones página 270

not try to force the product through the wood, let the cutting device
do the work, using the gripping teeth to apply minimal leverage
pressure.
10.Beware when reaching the end of the cut. The weight of the product
may change unexpectedly as it cuts free from the wood. Accidents can
occur to the legs and feet. Always remove the product from a wood cut
while it is running.
NOTE: The chain must be running at full speed before it comes into
contact with the wood.
Thin branches
Thin branches can be cut off with one single cut. To prevent the branch
from slivering and buckling the branch should be cut off in several pieces .
Thick branches
When cutting off larger branches three cuts are necessary.
1. First cut into the branch from below outside the place where you
intend to cut off the branch. The cut should go from one third to
halfway through the branch
2. Cut into the branch from the top outside at the same height the branch
is sawn from top.
3. Last, cut off the stump with one clean cut from top to bottom.
4. You might want to seal the cut with a suitable compound.
NOTE: Remove the branches lying on the floor regularly to avoid
stumbling hazards. Check the oil level regularly and fill up if necessary.
Switch the power off and disconnect from power source when leaving
the product.
•The appliance should be inspected before use and after dropping or
other impacts in order indentify any significant damage or defects.
•Do not use the machine in any position that causes to come any part
within 10m of overhead electrical lines.
• Hazards which may be encountered when using the pruner and avoid
them when carrying out typical tacks, and keep bystanders away
2. SAFETY INSTRUCTIONS
269
EN