4. Put the iron on the charging base, the Power
at the same time. After heating is completed, the Heating
Power
signal light will remain on,indicates that the selected temperature has been reached.
5.
At this time, you can use the Cordless iron about 25 seconds. As the temperature of the
soleplate reduction, repeat the step 4 to heating the iron.
6.
Once ironing is over or during breaks, place the iron on its charging base or place it vertically.
Spray function
Spray function sends extra water on clothes to eliminate the creases.
1.
The Spray head faces the clothes, and every time you press the Spray button , it will sprays
extra water on the clothes.
2.
The spray can be used in any position, either in dry or steam ironing, as long as the water tank
is filled with water.
Note:May need to press several times for the first use.
Steam Jet function
Steam jet sends a powerful gust of steam onto garments to eliminate the creases. This function is
also necessary for thicker textiles such as curtains.
1.
Put the iron on the charging base to heat it up,Adjust the Temperature control knob on MAX
and wait until the light is off. This will mean that the desired temperature has been reached.
2.
Put the iron on the clothes,Press the Steam jet button
can penetrate the fabric and smooth the more difficult and stiffest creases.
Advice : For a maximum quality, do not Steam jet more than three times in a row. Several
pumping actions are necessary to start this function. Keep in mind that an excessive use of this
function will cool the iron.
Auto-clean function :
1. Fill in the water tank and place the temperature control knob on MAX.
2. Plug in the apparatus, the lights on the charging base and the iron must be on.
3. Make sure the Steam switch to Off
4. Once the light is off, keep the iron is Horizontally over the sink and keep press the Auto-clean
and Heating
to produce a gust of steam which
.
42
Signal lamp(Fig C) will light up
signal lights will go out,and the