Orbitalum 790 048 765 Traducción Del Manual De Instrucciones Original página 11

AppARATeSTändeR/TRIpOd
WARnInG!
WARnInG!
[REV. 20190506] OC_Tripod_BA_790048765_00__INH-02_EN
Information and safety instructions for the responsible body
danger of tipping of the Tripod with tube saw!
Irreversible crushing.
X Ensure that the Tripod is mounted correctly (see chap. 3, p. 12).
X Ensure that the base plate is fastened to the Tripod before use (see chap. 3, p. 12).
X When cutting tubes always place one foot on the plate (see chap. 4, p. 13).
X Support tubes that project more than 40 cm (16") to the front from the cutting point with
an extension unit.
X Support tubes that project more than 100 cm (40") to the rear from the cutting point
with an extension unit.
X Place Tripod only on level surfaces that cannot subside.
Loose clamping parts!
Irreversible crushing.
X During mounting and after every transport of the Tripod ensure that all the screws at the
clamping sleeves and at the base plate are fastened tight (see chap. 3, p. 12).
X During mounting and after every transport of the Tripod ensure that both tubes are
pushed to the middle (edge-to-edge) of the clamping sleeves (see chap. 3, p. 12). This
will allow a safe stand of the Tripod.
> 1 m
> 0,4 m
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
11