Orbitalum 790 048 765 Traducción Del Manual De Instrucciones Original página 13

AppARATeSTändeR/TRIpOd
ITeM COde QTy.
1 790 048 392 1
2 790 048 394 4
3 305 505 276 4
4 305 505 222 12
5 790 048 397 3
6 790 048 395 3
7 305 505 272 6
4. MOUnTInG THe TUBe SAW On THe TRIpOd
IMpORTAnT!
X Ensure that the Tripod is mounted correctly (see chap. 3, p. 12).
X Mount the tube saw GFX 3.0, PS 4.5 or PS 6.6 onto the plate (1) of the Tripod using the screws supplied respectively:
– use the M12x30 screws to mount the GFX 3.0 (screw openings "A").
– use the M8x45 screws to mount the PS 4.5 and PS 6.6 (screw openings "B").
X Ensure that the base plate (12) is fastened to the Tripod before use (see chap. 3, p. 12).
X When cutting tubes always place one foot on the plate (12).
(A): GFX 3.0
1
(A)
(B)
[REV. 20190506] OC_Tripod_BA_790048765_00__INH-02_EN
ARTICLe
Tripod, plate
Clamping part
Cylinder-head screw
ISO4762-M8x35-8.8-ZN
Cylinder-head screw
ISO4762-M6x25-8.8-ZN
Tube 30 x 2 x 600
Clamping sleeve incl. screws
Cylinder-head screw
ISO4762-M8x25-8.8-ZN
Warning messages are used in these instructions to warn you of possible dangers, injuries or
damage to property. Always read and observe these warning messages!
To ensure safe operation please read all the warning messages in chap. 2, p. 10 attentively.
(B): PS 4.5 (Plus), PS 6.6
(B)
(B)
(A)
(B)
Mounting the tube saw on the tripod
ITeM COde QTy.
8 501 607 312 10
9 790 048 396 3
10 790 048 398 2
11 302 305 221 4
12 790 048 393 1
13 542 505 311 4
14 500 602 311 4
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
ARTICLe
Hexagon nut
ISO10511-M8-05-ZN
Tube 30x2x300
Round tube plug
Countersunk screw
DIN7991-M6x20-8.8-ZN
Base plate
Washer ISO7090-6-200HV-ZN
Hexagon nut ISO4032-
M6-A2
12
13