Making The Connections; Placement Of Speakers; Preparing The Remote Control - Panasonic SC-AKX70 Instrucciones De Funcionamiento

Reference
All the peripheral components and cables are sold separately unless indicated otherwise.

Making the connections

Connect the AC power supply cord only after all the other connections have been made. Connect the AC power supply cord only after all the other connections have been made.
Speaker connections Speaker connections
Speaker
Front (left and right)
Subwoofer

Placement of speakers

Speakers are designed identically so that no left or right channel
orientation is necessary.
You cannot take the front net off the speakers.
Use only the supplied speakers.
The combination of the main unit and speakers provide the best
sound. Using other speakers can damage the unit and sound
quality will be negatively affected.
Note:
• Keep your speakers at least 10mm away from the system for
proper ventilation.
• These speakers do not have magnetic shielding. Do not place
them near televisions, personal computers or other devices easily
infl uenced by magnetism.
• You can damage your speakers and shorten their useful life if you
play sound at high levels over extended periods.
• Reduce the volume in the following cases to avoid damage.
– When playing distorted sound.
– When adjusting the sound quality.
Caution
• Use the speakers only with the recommended system.
Failure to do so can damage the amplifi er and speakers,
and can cause fi re. Consult a qualifi ed service person if
damage occurs or if a sudden change in performance is
apparent.
• Do not attach these speakers to walls or ceilings.
20
RQT8043
AKX70_PN_LE_EN.indd 20 AKX70_PN_LE_EN.indd 20
Antenna connections Antenna connections
Place the antenna where reception is best.
Please refer to "Cómo conectar y
reproducir otra unidad externa" on
page 16 for more information on AUX
connection.
Terminal or
connector color
White
Purple
To household AC outlet
Power supply connection Power supply connection
Insertion of connector
Even when the connector is perfectly inserted,
depending on the type of inlet used, the front
part of the connector may jut out as shown in the
drawing. However there is no problem using the
unit.
Appliance inlet
Note:
• The included AC power supply cord is for use
with this unit only.
Do not use it with other equipment.

Preparing the remote control

Use alkaline or manganese batteries.
Insert so the poles (+ and –) match those in the remote control.
Aim at the remote control signal sensor (Z page 6), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
Note on using the remote control
• Do not mix old and new batteries.
• Do not use different types of batteries at the same time.
• Do not take apart or short circuit the batteries.
• Do not attempt to recharge alkaline or manganese batteries.
• Do not use batteries if the covering has been peeled off.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
• Mishandling of batteries in the remote control can cause
electrolyte leakage, which may cause a fi re.
• Remove the batteries if the remote control is not going to be used
for a long period of time. Store in a cool, dark place.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Connector
3/9/2010 9:05:33 AM 3/9/2010 9:05:33 AM