Technical Data; Installation - IKEA SMAKOKA Manual Del Usuario

ENGLISH

Technical data

Dimensions
Width (mm)
Height (mm)
Length (mm)
Voltage (V))
The technical information are situated in the
rating plate on the bottom side of the appliance.

Installation

After unpacking the hob, make sure that it
has not been damaged during transport. In
the event of problems, contact the dealer or
your nearest After-sales Service.
Technical information for the installer
This product can be embedded in a worktop
20 to 50 mm thick.
- If there is no oven beneath the hob, insert
a separator panel that has a surface at
least equal to the opening in the work
surface. This panel must be positioned in
no case less than 20 mm from the bottom
of the hob.
- Before installation, make sure that:
- the local gas delivery conditions (nature
and pressure) are compatible with the
settings of the hob (see the rating plate
and injector table);
- the outer surfaces of the furniture or
appliances adjacent to the hob are heat
resistant according to local regulations;
580
40
510
220 - 240
- This appliance is not connected to a
fume exhaust device. It shall be installed
in accordance with current installation
regulations. Particular attention shall
be given to the relevant requirement
regarding ventilation.
- Combustion products are discharged
outdoors through specific hoods or wall
and/or window mounted electrical fans.
Gas connection
This operation must be performed by a
qualified technician.
The gas supply system must comply with
local regulations to the relavant gas
standard.
27