Intended Use; Identification Plate; Operating Controls; Start-Up - Wolf Garten TL 32 eM Manual De Instrucciones

Intended use

Intended use
This tool is intended solely
- to be pruning shears for pruning or cutting back
branches on high trees or shrubs with a maximum
branch thickness of 32 mm. In the case of hard
wood, the maximum diameter is accordingly less.
- for use in accordance with the descriptions and
safety instructions given in this operating manual.
The pruning shears are not designed for commercial
use and may only be used in home gardens and
allotments.
Any other use is classed as an unintended use.
The user is liable for any damages arising from
unintended use.

Identification plate

Position
The identification plate is located on the housing of
the device.
Note
The label has the status of a certificate. It
must never be altered or obliterated.
Structure G
1 Manufacturer
2 Device group
3 Model name
4 Rated voltage, current type
5 Weight
6 Disposal note
7 Year of manufacture
8 Guaranteed sound level
9 CE label
10 Model number
11 Serial number

Operating controls

Operating elements H
1 Lock-on switch
2 On/off switch on handle
3 Handle
4 Holding area forthe hand / fastening area for the optional
middle handle
5 Operating arm *(with permanently installed power pack)
6 Fastening wheel for adjusting the working angle
7 Cutting blade/cutting tool
*Necessary operating element (not supplied)
Supplementary documentation
Make sure the supplied instruction
manuals of the charger and operating
arm are available. Please read and
understand them before using the
device.
Power pack charging
Only charge the power pack using the
charger approved by the manufacturer.
The designations of the approved chargers
are listed in the enclosed CE Declaration of
Conformity.
Attention!
The power pack is supplied partially charged.
Before using the device for the first time, fully
charge the power pack to ensure effective
performance.
The power pack is permanently installed in
the operating arm.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.

Operation

Operating times
Please observe the times stipulated in local byelaws.
Check with your local authorities to determine if
there are any operating time limitations.
Adjusting the working angle A
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Before any work on the device, first
remove the operating arm with the
permanently installed power pack.
The device has an infinitely adjustable working
angle with a radius of max. 225° (depending on the
model and design). This allows you to easily reach
problematic and difficult-to-access positions.

Start-up

WARNING!
CAUTION!
WARNING!
EN
23