Rotary Switch And Push Button; Led Lighting And Fan - BETEX iDuctor 1 1200W Manual Del Usuario

CAUTION!
When using the flexible induction coil it is important to wind as few turns
around the object as possible. Where excessive turns are wound the
current amperage will rise too high and the safety cut-out will trip. The
optimal number of turns will vary between objects. Start with a single
turn and gradually increase the number of turns as necessary.
CAUTION!
If the iDuctor is used in one of the lower power settings it may produce a
ticking sound: this is normal and not a fault.

3.5 LED lighting and fan

The LED on the front of the unit will light up to illuminate the object when you press the
button. The fan will then run to cool the system. The fan will remain active throughout the
heating process and also thereafter if the measured internal temperature is high. Once the
temperature has returned to a normal level the fan will switch off automatically. For this
reason the 230 Volt mains connection should be maintained until the fan stops running. The
iDuctor will switch off (or fail to switch on) if a fault is detected. In that case the LED light will
flash when the button is depressed. (See: "Error messages".)
8
3�4 Rotary switch and push button
The patented rotary switch at the rear of the
iDuctor is used to adjust the heating time and
power. These adjustments should be made
before you press the push button on top of the
unit to activate heating. The settings can not
be adjusted during heating. Once adjustment
is complete the coil is held around the object
to be heated and the button on top of the unit
is depressed. In positions 1 to 5 the unit will
switch off automatically after the specified time.
In position 6 the unit will continue to heat until
the button is released or the iDuctor is switched
off by the internal temperature safety cut-out.
Once the iDuctor has cooled sufficiently the
heating process will start up again automatically
when you press the button. The iDuctor is active
when the LED on the front is illuminated.
© BETEX Tools