Sauder 414444 Instrucciones De Montaje página 10

Step 6
å
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into the
PANELS (F2) until the shoulders of the SCREWS rest on the
surfaces of the PANELS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the PANEL MOLDINGS (K) onto the PANELS (F2). Line
up the grooves in the MOLDINGS over the heads of the
SCREWS in the PANELS.
å
NOTE: The MOLDINGS should be centered on the PANELS.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
Finished edge
Shoulder
Apply pressure with your hands as
you guide the MOLDINGS over the
SCREWS and onto the PANELS.
Page 10
Finished edge
F2
F2
414444
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
K
K
www.sauder.com/services
32S