MaxPro PROFESSIONAL MPBMS255LS Manual De Instrucciones página 12

-Before remove the work piece ensur
13.Mitre-cuts ( rotary table 0 degree )
The crosscut saw can be used to make mitre cuts of 0-45 in r
- Adjust the bevel lever handle (fig. 13)
- Loosen the bevel lever handle (18)
- Turn the table (8) of the machine into the desir
-R
-Hold firmly the handle (1) and press the on off switch (15), the saw blade will start running and w
reach his maximal speed.
-Unlock the guard lock handle (2) and push slowly the handle (1) and keep pr
completely (fig 15.)
-Before remove the work piece ensur
14.Mitre-cuts ( rotary table 0 degree ) and rotary table 0-45 degree
The crosscut saw can be used to make mitre cuts of 0-45 in r
0-45 degree in r
-Set the rotary table at desir
-Loosen the table lock handle (7)
-Press and keep pr
-R
-Adjust the bevel lever handle (fig. 13)
-Loosen the bevel lever handle (18)
-Turn the table (8) of the machine into the desir
-Hold firmly the handle (1) and press the on off switch (15), the saw blade will start running and w
reach his maximal speed.
-Unlock the guard lock handle (2) and push slowly the handle (1) and keep pr
completely (fig 15.)
-Before remove the work piece ensur
15.Replacing the saw blade. ( Fig. 17 – 20 )
-Before changing the saw blade, remove the power plug !
-Wear work gloves to prevent injury when changing the saw blade.
-Loosen the screw (25a) on the cover plate (25)
-Pull back the adjustable blade guar
dir ve access to the flange bolt.
-Pr
Allen key (22) on the flange bolt (26)
-Loosen with some force the flange bolt (26) with the Allen key (22 ) at clockwise dir
-Turn the flange bolt (26) right out and remove the flange (28), while remove the flange (28) hold the saw
blade (3) in your hand.
-Take the saw blade (3) off the inner flange and pull it out downwards.
-Careful clean the flanges and the flange bolt (26)
9
release the on / off swi
vel lever handle (18)
release the on / off swi
rail. ( double mitre cut )
vel lever handle (18)
release the on / off swi
r
GB
work face.
can be read out from indicator ( 18a)
work piece is cut
work f
r
can be read out from indicator ( 18a)
work piece is cut
wards.
cover plate (25) at the upper