Sauder 427970 Instrucciones De Montaje página 8

Step 3
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in
the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (C and D). Use sixteen 3/8" PAN
HEAD SCREWS (20) through the holes shown in the enlarged diagram.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Open end
Push the black lever in and pull the SLIDE from the RAIL.
1
C
Page 8
2
1
Open end
www.sauder.com/service
20
3/8" PAN HEAD SCREW
(16 used in this step)
1
1
7
1
D
Open end
427970