Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1 - PREP
1.
Clean your toilet
2.
Turn off the cool water supply at the wall beside the toilet
3.
Turn off the warm water supply underneath the sink
4.
Drain the toilet tank completely by flushing the toilet
STEP 2 – ATTACH YOUR RAISED TOILET SEAT
1.
Turn both locking clamps counterclockwise until
they can no longer turn - this will open the locking
devices.
2.
Place raised toilet seat onto the bowl and position
securely. Be sure the two locking brackets are on
both sides of the bowl wall and that the seat is flush
to the bowl.
3.
Turn the locking brackets clockwise until tight, hand
tighten only. Do not use tools as threads on adjust-
ment bracket may strip.
NOTE:
•
Check for secure fit routinely before using product.
•
User's weight should be centered over toilet seat.
STEP 3 – COOL WATER CONNECTION
TIPS
•
You may need a wrench to disconnect the water supply hose.
•
Use a bucket or towel to catch excess water
1.
Disconnect the existing water supply hose
from the toilet tank
2.
Ensure o-ring is placed in the large adapter
3.
Attach the large adapter to the toilet tank
connection and screw the flexible steel
hose to the bottom connection
4.
Attach provided cool water supply hose to
the large adapter's side connection
STEP 4 – WARM WATER CONNECTION
TIPS
•
You may need a wrench to disconnect the water supply hose.
•
Use a bucket or towel to catch excess water when disconnecting the water
supply hoses.
•
If a vanity cabinet is present you may want to drill a hole to accommodate the
water supply hose
installation instructions
- 3 -
C
H
Publicidad
Tabla de contenido
