Dip Switch Settings - Furrion CHILL ACR13SA Serie Manual De Usuario

Foil tape
9. Measure the height of the duct divider, and cut the PE foam
with a utility knife to the measured dimension. Peel paper
backer of foam to reveal sticky adhesive. Evenly adhere PE
condensation foam to duct divider, working material into
crevices and surfaces for a tight uniform fit across the duct
divider surface.
Duct Divider Height
PE Foam

DIP Switch Settings

The DIP switches enable/disable different communications
between the ceiling controller and wall thermostat for functions
such as, zone selection, furnace operation, and additional
accessories.
The controls are preset with the following active DIP switch
settings:
Single Zone: Furnace on (FACC12SA-BL)
Multi Zone: Zone 1; Furnace on (FACC12ZA-BL, FACC12NA-
BL, FACC12ESZA, FACC12ZA, FACC12HE, FACC12ESHE
Location of the DIP Switch
The DIP switches are located on the PCB board of the control
box. Each time you want to set the DIP, you should open the
control box and find the DIP switches.
1. Remove the cover of the control box, and find the PCB
board.
Measured Duct
Divider Height
2. Locate the position of the DIP switches on the PCB board.
PCB Board Location
Setting DIP Switches
Electrical Shock Hazard
Disconnect power before servicing. Failure to obey this
warning could result in death or serious injury.
1. Remove power when setting dip switches, make sure all
115VAC and 12VDC power to the control board is removed.
2. Use a small tool, slide the dip switch to either ON/OFF.
NOTE: If 12V+ is present when making a setting change, It will
be is necessary to cycle power to reset the control to make the
setting active.
Single Zone DIP Switches:
ON
Heat Pump
DIP 3
(selected models)
Furnace DIP 4
Electric Heat
DIP 5
(selected models)
Analog / Digital DIP 6
Multi Zone DIP Switches:
●
Each zone requires an independent ceiling control box, but
will share one wall thermostat control.
●
It is important that each independent zone is set to a
unique zone value (1-4) by setting the DIP 1 and DIP 2 to
avoid repetition and communication conflicts with the wall
thermostat control.
- 8 -
DIP Switches Location
DANGER
5
3 4
Reserved
OFF Furnace Off
ON Furnace On
OFF Electric Heat Off
ON Electric Heat On
OFF Digital
ON Analog
CCD-0005730 Rev: 04-25-22
6