Open rings MODELS SERIES K6 - C2
In order to switch on the burner of gas open rings, proceed in the following way:
Turn the knob (1) from OFF
the button;
Light the burner using a match or another lighter suitable for this use;
Once lit, keep the knob pressed down until the thermocouple heats up,
keeping the burner lit up (it will take some seconds);
Light the main burner in the desired position, going from maximum
In order to put out the main burner, the knob has to be turned to the right into OFF position
NOTICE1: In the case of the appliance is provided with the option of spark ignition system:
-
2.a. Press the push-button down until the gas burner until the thermocouple heats up, then adjust the flame
in the desired position, going from maximum
NOTICE2: In the case of the appliance is provided with the pilot burner:
2.b. Light the pilot burner using a match or another lighter suitable for this use;
3.b. Once lit, keep the knob pressed down until the thermocouple heats up, keeping the pilot lit;
4.b – Light the main burner in the desired position, going from maximum
Gas oven 1/1 GN MODELS SERIES K6 – C2
In order to light the oven burner, proceed in the following way:
-
Open the oven door and turn the knob (1) from the OFF position
position
;
-
Press down the button;
-
Light the oven burner pressing the button of the electric spark ignition (2)
-
Keep the knob pressed down until the thermocouple heats up,; this can be
checked through the slit in the stainless steel bottom;
-
Position the knob in one of the possible positions, choosing the one most suited
to the type of cooking desired, considering that they correspond indicatively
to the temperatures shown below:
Position (N°)
Temperature (°C)
In order to put out the main burner, the knob has to be turned to the right into the OFF position
INSTRUCTIONS FOR USE
●
position counter-clockwise; press down to
1
2
3
150
171
192,5
17
to minimum
●
4
5
214
235,5
17/44 en
to minimum
.
●
.
to minimum
into the
6
7
257
278,5
8
300
●
.