Care & Maintenance - Danby Designer DDEF02213BD13 Manual Del Propietário

CARE & MAINTENANCE
CLEANING
1. Ensure the power is turned off
and the fi replace is unplugged.
2. Allow the fi replace to
completely cool before
attempting any cleaning.
3. The outer shell may be cleaned
with a soft, damp cloth. A
mild detergent can be used
if necessary. After cleaning,
dry the fi replace with a soft
cloth. Do not let liquid enter the
fi replace.
4. Wait until the fi replace is
completely dry before using.
WARNING: Do not immerse the
fi replace in water or allow water to
enter the fi replace.
WARNING: Do not use alcohol,
gasoline, abrasive powders,
furniture polish or rough brushes to
clean the fi replace. This may cause
damage or deterioration to the
surface of the fi replace.
STORAGE
Store the fi replace in a cool,
dry location when not in use. To
prevent dust and dirt build-up, use
the original packaging to repack
the fi replace.
TROUBLESHOOTING
If the fi replace will not operate,
check the following:
1. Check that the power cord
is plugged into a 120 V AC
electrical outlet. Do not use
extension cords.
2. Check that the power indicator
light on the control panel is
illuminated to show that the
fi replace is getting power from
the outlet.
3. Check if the battery in the
remote control needs to be
replaced.
4. Unplug the fi replace, wait
15 minutes for the internal
components to reset and then
plug it back in.
13