Potensic T25 Manual Del Usuario página 6

2. Check the Battery Level
3. Charging the Battery and Transmitter
Tip: When the transmitter is in low power, the power indicator light on the
transmitter will keep flash, you need to charging the transmitter this time.
1. Balanced charging: If the power switch of the quad-copter is on the state ON / OFF, The drone can be charged. Insert the USB cable into the USB port of
a computer, and then connect with the charging port of the drone. When charging,the indicator on the power switch will become blue blinking; When fully
charged,all indicators on the power switch will turn solid blue.
2. Drone battery can be charged by the mobile power or car-loaded power.
3. Full charging time takes about 60 minutes, Flight time about 10 minutes.
4. Remote lithium battery Full charging time takes about 50 minutes.
CAUTIONS WHEN CHARGING:
1. When charging, please put this product in a dry ventilated area and keep it far away from heat sources or flammable products.
2. When charging, it is recommended to remove the batteries from the quadcopter. Charging process should be supervised by an adult so as not to cause an
accident. The battery can also be charged while in the quadcopter.
3. After flying, please do not charge the battery if the surface temperature is still warm. If the battery has been used for a long time, or appears to be swollen,
please replace them.
4. Please make sure that you use the original USB charging cable provided.
5. A battery when not in use for a long time will lose its charge automatically. Charging or discharging too often may reduce the life of the battery.
DISCLAIMER: You must use the original USB cable and standard 5V wall charger.
WARNING: Never charge with an input stronger than 5V. This can cause the battery to overheat.
Step 1: Turn on drone and set down on a horizontal surface
— The drone will auto-trim to this level surface.
— All lights blinking red.
GPS CALIBRATION (CONTINUED)
Step 3: Reset to Factory Setting / Calibrate Gyroscope
— Press the Joysticks into the 11 & 1 o'clock positions.
— Lights rapid-blinking blue (back) and white (front).
— App Drone Status: "Gyroscope is being calibrated"
"Gyroscope okay".
Step 5: GPS Compass Calibration Part 1
— Keeping the drone level, pick up the drone from the back
and rotate your body in one full circle (360°).
— Back lights will turn to a solid blue.
Step 7: Finalize GPS Calibration
— Set drone back down to horizontal surface.
— Lights return to rapid-blinking blue (back) and white (front)
— This means the drone is finalizing its GPS calibration.
— This process can take a few minutes.
— App Drone Status: "Waiting for GPS signal".
Low Electricity High
Press the buckle and Pull out
the Battery from the drone.
LITHIUM BATTERY CHARGING INSTRUCTIONS
PREPATATION FOR FLIGHT/GPS CALIBRATION
Front
Phone Adapter: Charging Time:
5V 1A/2A About 60 minutes
(Not included)
Please choose the spacious indoor or outside environment for flying, also it
requires that it should be flied under the weather of non- snow or non-storm with
wind force less than Level 4. When flying, please DO keep it far away from the
crowd, tree, electric wire, skyscraper, airport or signal transmitting tower, etc.
Step 2: Turn on remote
— Press Up, then Down on the left joystick.
— Lights flashing blue (back) and white (front).
— NOTE: You can connect to the WiFi at this time to view the
current drone status on the Potensic-G App, or wait until
after GPS is calibrated.
Step 4: Initiate GPS Compass Calibration
— Joysticks at the 1 & 11 o'clock positions(as the picture show).
— Lights rapid-alternate between blue/red (back) and white/red
(front).
— App Drone Status: "Compass calibration".
Step 6: GPS Compass Calibration Part 2
— From the bottom, hold the drone face-down and rotate the
your body in one full circle(360°).
— Front lights will turn to a solid white.
— App Drone Status: "Compass calibration okay".
Once the lights have switched to all solid, you are ready to fly!
— Blue (back) and white (front) lights are all solid (no blinking).
— App Drone Status: "Ready to fly".
04
Charging Time of
the Transmitter:
(Depending on
About 50 minutes
Charging Power)