Freestanding Installation; Wall Mounted Installation - THERMEx HeatMex Instrucciones De Montaje

42 THERMEX HeatMex
INSTALLATION
• Before installing, check that all parts are complete and the product is intact.
• If you want to use the electric heater freestanding, please fit with the feet provided with the heater, following the
instructions below. Make sure the heater is mounted on a level, stable and clean surface.

FREESTANDING INSTALLATION

1. Put the product upside down on a soft cotton
cloth or carpet.
2. Fix the feet to the base of the heater using the
screws provided. Line up the holes in the base with
the holes in feet, put the screws through the holes
and tighten with a screwdriver.
ATTENTION: Make sure to face the lockwheel
forward.

WALL MOUNTED INSTALLATION

1. Remove the wall bracket from HeatMex by pulling
HeatMex 500W/
out the locking clip and releasing the bracket.
750W/1000W
218 mm
218 mm
2. Mark the wall according to the dimensions below,
130 mm
live in the wall, insert rawplugs. Mount the wall
bracket.
3. Attach the electric radiator to the wall bracket,
insert first the lower two hooks, then the two upper
hooks on, and push up so that the HeatMex is
locked.
HeatMex 500W/
Distance
750W/1000W
A 218 mm
B 218 mm
C 130 mm
NOTE: For safety reasons, Heatmex must be
mounted at a distance to the floor and objects
above.
Mine. 50mm from Heatmex to floor.
Mine. 150mm from Heatmex for items above.
WARNINGS!
Prior to drilling the wall, ensure there are no cables or pipes within the wall and ensure that the
mounting screws are fixed firmly to guarantee that the heater is safely mounted to the wall.
HeatMex 500W/
Distance
750W/1000W
A 218 mm
B 218 mm
C 130 mm
HeatMex 500W/
Distance
750W/1000W
A 218 mm
B 218 mm
C 130 mm
1.
3.
3a
3a
3c
M 140210500228022022
2.
3c
3b 3c
3b
MIN.
150 MM
MIN.
50 MM