Wifi Setup And Smart Setup; Offset - Temperature Adjustment - THERMEx HeatMex Instrucciones De Montaje

44 THERMEX HeatMex

WIFI SETUP AND SMART SETUP

1. To connect your heater to the WiFi, the first step is to download the third-party Smart Life app onto your smart-
phone or tablet. You can find the app by scanning the QR code below or searching "Smart Life" in the Google Play
or Apple app store. Unless you already have a Smart Life account, you will need to create an account. Follow the
instruction in the app.
ATTENTION! Only use 2,4 GHz wifi network.
2. To add your heater to the app, first put the heater in WiFi connection mode. The heater is in WiFi connection mode
when the WiFi icon is flashing. If the wifi
button for three seconds.
3. Once the icon is flashing, go to the app and follow the instructions to Add a Device. This is done either via the
Auto-Scan function, or manually be adding the device from (Small Home Appliances > Heater) and confirm that
the indicator is flashing.
4. The heater will beep and display a solid
ater has been added. You can now name the device, share it with family members, or proceed to scheduling your
heating.
noTE if the heater is failing to connect, press and hold the
to its secondary connection mode. The heater has two connection modes: one where the
per second) and one where the
flashing mode.
From within the third-party app, you have access to the following features:
• Controlling your HeatMex from your smartphone
• Configure scheduled heating from your smartphone
• Add customisable and intuitive commands via scenarios
• Configure Voice Integration with both Amazon Alexa and Google Home.
HeatMex memory funktion husker på de valgte indstillinger, når apparatet frakobles strømmen eller yttes
Please refer to the Smart Life app for instructions on how to configure the above mentioned.
ATTENTION!
Thermex is in no way associated with or responsible for the third-party app, as this is developed, updated and distri-
buted by a seperate entetity.

OFFSET - TEMPERATURE ADJUSTMENT

If HeatMex is used in particularly small or large rooms, it may be necessary to adjust the temperature. The
adjustment is made by holding down the MODE button for 3 seconds, after which the UP and DOWN buttons
are used to adjust the measured room temperature. Set with a + offset if the room temperature is too high,
Hvis HeatMex anvendes i særligt små eller store rum, kan det være nødvendigt at indjustere temperaturen. I
Set with a - offset if the room temperature is too low.
icon is not flashing, go to standby mode and hold down the
icon when the device is connected.The app will confirm that the he-
icon flashes fast (three times per second). Most devices will connect on the fast
3
s
3 sec.
button for three further seconds. It will then switch
M 140210500228022022
icon flashes slowly (once